Instructions for the Evicted Script Rust

Below will be instructions for installing and starting the spoofer, follow the instructions carefully and then everything will work.

📕Preparing for launch

To start using Evicted Script, make sure that you do NOT have the following programs installed.

• WIRESHARK

• PROCESS HACKER

• HTTP DEBUGGERS

⚠️Disable Windows Defender

📗Startup and Installation

❗ Важно: Перед началом установки убедитесь, что Steam полностью закрыт!

Step 1 — Download Required Files

Download both necessary files:

• ⬇️ Loader — Download Here
• ⬇️ Components — Download Here

Step 2 — Install Drivers

1. Open the downloaded Components folder.
2. Navigate to the [NEED TO INSTALL] folder.
3. Install both drivers inside.

Step 3 — Run Components

• Double-click Components.exe.
• Wait until the download completes.
• ✅ You should see a Success message when finished.

Step 4 — Set Up Loader

1. Insert your Flash Drive into the PC.💡 Don't have a physical USB? Use the provided Viratual USB DRIVE
   Virtual USB DRIVE (Win 11) - Click
   Virtual USB DRIVE (Win 10) - Click
   
   
2. Copy Loader.exe into your Flash Drive. (It will automatically generate a random name for the file.)

Step 5 — Launching the Script

1. Open the Loader from your Flash Drive.
2. Select your game:✅ Select YES for Rust❌ Select NO for Valorant

⚠️ Your PC will restart automatically after selection.

Step 6 — Final Setup

1. After reboot, run the Loader again.
2. A new .exe file with a random name will be created.
3. Run the new file and enter your Activation Key.

When the Evicted menu appears:

• Click OK — The Loader will close automatically.

Step 7 — Ready to Play!

✅ Safely eject your Flash Drive.

Launch your game and enjoy!

Recommended Script Customization

1. Go to Settings (on the second page).
2. Enable:Detect ingame settingsAutoDetect (found under Misc tab)
3. Detect ingame settings
4. AutoDetect (found under Misc tab)

ℹ️ If nothing responds — your game settings were automatically detected.

Setting Up Evicted Auto Weapon Detection System

1. Enable Auto Features 🚀

Navigate to Misc Section:

Open the Misc tab in your program.

Enable Auto Functions:

• Turn on Auto Detection
• Turn on Auto Scope

⚠️ Important: Make sure your in-game resolution matches your desktop resolution (example: 1920x1080 in both Rust and Windows).

This is crucial for correct detection.

2. Configure Detection Settings ⚙️

Open the Settings tab to adjust detection parameters.

Main Parameters:

ParameterDescription

UserConfidence

Detection sensitivity (higher = stricter).

DetectionMS

Detection speed in milliseconds.

Recommended Settings:

Using stretched resolution? 📏 Set UserConfidence to around 60% for better detection accuracy.

Want faster gun detection? 🔫⚡ Lower DetectionMS to 300ms for quicker response.

Low-end PC? 🥔 Keep DetectionMS at 500ms to avoid performance issues.

3. Set Up Keybinds 🎮

Navigate to the Keybinds section to configure your hotkeys.

Available Keybinds:

KeybindFunction

Redetect Key

Force re-detect your weapon (useful on UKN).

SightKey

Auto-detect your current gun scope.

AutoDetect Key

Toggle auto detection on/off.

4. Test Your Setup ✅

Step 1 — Run a Test:

Test your configuration on a practice server (like UKN) to ensure everything works correctly.

Step 2 — Ready for Fights:

Once you are happy with your settings — you’re good to go for real fights.